DescriptionThis 3D-printed Raspberry Pi 4 case with SSD slot has been designed to perfectly combine an SSD with your Raspberry Pi. The enclosure has following features:a well-ventilated case, which helps heat dissipation and thereby prevents loss of performance of the processor (= essential for the Raspberry Pi 4 B!)SSD slot for typical 2.5-inch Solid State Drives (7mm height)cut-out for displaycut-out for cameracut-out for GPIO-cablea cooling fan can be mounted (30x30x7 mm, available as an option), only necessary for intensive CPU usageDIN rail mountable with separate supports (available as an option) Also included :USB 3.0 type A to SATA III 10cm cable for high-speed data transmission3 heatsinks for Raspberry Pi 4 with thermal adhesive (easy to mount)4 screws4 adhesive bumpersExcluded :Raspberry Pi 4B boardSSDRemarks :The SSD can be used as an extra drive while you continu to use your SD-card for the Operating System.It’s a better option to run the Operating System of your Raspberry Pi on the SSD. In this case, you need to change your Pi’s firmware. But once done, you don’t even need a microSD card any more!We 3D-print our self-developed cases in our lab. To print the cases, we use PLA, an eco-friendly raw material.We developed this setup to avoid the use of a micro-SD-card. However, you can still use a micro-SD-card, but you’ll need to open the enclosure to change the card.
